Selected:

L298N 2A DUAL MOTOR DRIVER MODULE

150.00

L298N 2A DUAL MOTOR DRIVER MODULE

(1 customer review)

150.00

  1. Current Sense for each motor.
  2. Heatsink for better performance.
  3. Power-On LED indicator.
  4. Double H bridge Drive Chip: L298N.
  5. Operating Voltage(VDC): 5~35
  6. Peak Current (A): 2
  7. Continuous Current (A): 0-36mA
  8. No. of Channels: 2
  9. Over-Current Protection (A): Yes
  10. Thermal Protection: Yes
Add to Wishlist
Add to Wishlist

Description

L298N 2A Based Motor Driver is a high power motor driver perfect for driving DC Motors and Stepper  motor.

It uses the popular L298 motor driver IC and has an onboard 5V regulator which it can supply to an external circuit. It can control up to 4 DC motors, or 2 DC motors with directional and speed control.

This motor driver is perfect for robotics and mechatronics projects and perfect for controlling motors from microcontrollers, switchesrelays, etc. Perfect for driving DC and Stepper motors for micro mouse, line following robots, robot arms, etc.

Connection Diagram

L298N_DC_Motor-1024x697

 

FRJ7W76HZDYE1YD.MEDIUM

Usage:

H-bridges are typically used in controlling motors speed and direction but can be used for other projects such as driving the brightness of certain lighting projects such as high powered LED arrays.

How it works:

An H-Bridge is a circuit that can drive a current in either polarity and be controlled by *Pulse Width Modulation (PWM).

* Pulse Width Modulation is a means in controlling the duration of an electronic pulse. In motors try to imagine the brush as a water wheel and electrons as the flowing droplets of water. The voltage would be the water flowing over the wheel at a constant rate, the more water flowing the higher the voltage. Motors are rated at certain voltages and can be damaged if the voltage is applied to heavily or if it is dropped quickly to slow the motor down. Thus PWM. Take the water wheel analogy and think of the water hitting it in pulses but at a constant flow. The longer the pulses the faster the wheel will turn, the shorter the pulses, the slower the water wheel will turn. Motors will last much longer and be more reliable if controlled through PWM.

Pins Details

Out 1: Motor A lead out
Out 2: Motor A lead out
Out 3: Motor B lead out
Out 4: Mo (Can actually be from 5v-35v, just marked as 12v)
GND: Ground
5v: 5v input (unnecessary if your power source is 7v-35v, if the power source is 7v-35v then it can act as a 5v out)
EnA: Enables PWM signal for Motor A (Please see the “Arduino Sketch Considerations” section)
In1: Enable Motor A
In2: Enable Motor A
In3: Enable Motor B
In4: Enable Motor B
EnB: Enables PWM signal for Motor B (Please see the “Arduino Sketch Considerations” section)

 

Additional information

Weight 40 g
Dimensions 6 × 6 × 3 cm

1 review for L298N 2A DUAL MOTOR DRIVER MODULE

  1. Jaspreet

    Driver works fine, best price

Add a review

Your email address will not be published. Required fields are marked *

Close Menu
×
×

Cart